void setup () { - Sets up the pins that will be used, only runs once, pinMode(#, OUTPUT); - Sets up the mode of the specific # pin to put out an action from an inputted code, void loop () { - Sets up the functions that will be repeated infinitely, digitalWrite (#, HIGH/LOW); - The code makes the digital pin 13 an OUTPUT and toggles it by alternating between HIGH (On) and LOW (Off) voltage, delay (1000); - The amount of time the action occurs, measured in milliseconds, Brackets - enclose the function being run,

Dissecting the 'Blink' Function

от
Внедрить

Таблица лидеров

Визуальный стиль

Параметры

Переключить шаблон

Восстановить автоматически сохраненное: ?